RIB ACG2266W, Инструкция по эксплуатации, Страница: 21 / 44

21
10
REMOVING A TRANSMITTER
10.1 Removing a transmitters from the control unit
REMOVING transmitter
To delete one channel or the whole transmitter it is necessary to access to the internal menu of the transmitter.
To do this refer to the instructions of the transmitter in possession..
Warning: Do not use this procedure if you have multiple units in operation, since the store opening would affect all devices where the channel
is stored. In this case, disconnect the power supply of the
control units which shall not be involved
9
TROUBLESHOOTING
Problem Possible causes Solutions
When power up the control unit no LED
come up • Missing power supply
• Plug is not connected
• Power failure • Wait until it comes back
• Insert the plug
• Check the connections, see paragraph
3
Transmitters keys doesn’t work • Transmitter isn’t learnt on the control
unit
• Low battery on the transmitter
• Radio module not present or broken
• Follow the procedure on paragraph 4.1
• Change the battery
• Insert the radio module or change it
Red LED continues blinking • One or more sensors in allarm
• Broken or low power on sensor
• Sensor disconnection • Need a technical intervention
• Check the 8 LEDs to understand which
sensor is in alarm
• In case of disconnection (fast blinking
of red LED) and you need to move the
awning, set to OFF DIPs 5, 6, 7, 8