[16]
6)
To minimize stalling or breaking through
the material, reduce pressure on drill
and ease the bit through the last
fractional part of the hole.
7)
Keep the motor running when pulling
the bit back out of a drilled hole. This
will help prevent jamming.
MAINTENANCE
WARNING!
:
To reduce the risk of
serious personal injury, turn tool off and
remove the battery pack before making
any adjustments or removing/installing
attachments or accessories
. An accidental
start-up can cause injury. Cleaning
WARNING!
Blow dirt and dust out of
all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury,
always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING!
Never use solvents or other
harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals
may weaken the plastic materials used in
these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid
get inside the tool; never immerse any part
of the tool into a liquid.
CHARGER CLEANING
INSTRUCTIONS
WARNING!
Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be removed
from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use
water or any cleaning solutions.
ACCESSORIES
WARNING!
Since accessories, other
than those offered by RHYNO, have not
been tested with this product, use of such
accessories with this tool could be
hazardous. To reduce the risk of injury,
only RHYNO recommended accessories
should be used with this product.
Recommended accessories for use with
your tool are available at extra cost from
your local distributor. If you need any
assistance in locating any accessory, please
contact RHYNO at 844-25RHYNO (844-257-
4966) or visit www.RHYNO.com.
MAXIMUM RECOMMENDED
CAPACITIES
Repairs
The charger and battery pack are
not serviceable.
WARNING!
To assure product
SAFETY
and
RELIABILITY,
repairs,
maintenance and adjustment should be
performed by a RHYNO factory service
center or a RHYNO authorized service
center.
Always
use
identical
replacement parts.
Wood
Auger
1 1/4"/32 mm
Paddle
1 1/2"/38 mm
Twist
1/2"/13 mm
Self Feed
2 9/16"/65 mm
Hole Saw
4"/100 mm
Metal
Twist Bit
1/2"/13 mm
Hole Saw
1 3/8"/35 mm
Masonry
Carbide
1/2"/13 mm
Material
Tool Diameter
(IN/MM)
