7
Arming and Disarming Your Immobilizer
Activate Panic or Car Finder Function
Remote Boot (Trunk) Release
Programming Additional Remote Controls / Erasing Lost Remote Controls
Overriding the Immobiliser
TO ARM YOUR IMMOBILISER (& lock your vehicle if central locking is connected)
Pressing the
⁄
button on the remote control transmitter activates the immobiliser. The blinkers will flash
once and the siren will beep once. For
silent arm / disarm
press
⁄
and
both buttons If central
locking is connected, your doors will lock. The dash LED-light will stay on for 20 seconds then flash,
THE
IMMOBILISER IS NOW ON.
Blinkers will flash once
LED COMES ON……….and after 20 seconds starts to flash.
…
TO DISARM YOUR IMMOBILISER (& unlock your vehicle if central locking is connected)
To deactivate the immobiliser, press the
⁄
button. The blinkers will flash twice and the siren will beep
twice. The LED will stop flashing. If central locking is connected, your doors will unlock.
THE IMMOBILISER
IS NOW OFF.
Note:
If the alarm has been activated in your absence, the siren will beep 4 times on disarm.
Pre
Blinkers will flash Twice
LED Switches OFF
…
Your Jagv2/RAv3 is supplied standard with 2 remote controls - Up to a maximum of 5 remotes can be used. To add a
new remote to your alarm, simply follow the procedure below:
1. Turn the vehicle’s ignition to on.
2. Immediately press and hold the
/
button on the original remote control until the indicators start
to flash (approximately 4 seconds) and then release the button.
3. Immediately press and hold the
/
button on the new remote control for at least 4 seconds.
4. Turn the vehicle’s ignition off.
5. The new remote control is now programmed into the immobiliser.
Erasing Lost Remote Controls:
If you lose a remote control or perhaps have your car keys stolen, you can
simply erase the lost/stolen remotes by repeating the procedure above 10 times. This will fill the system memory with
remotes that only you have in your possession.
Learning in a new remote when no working remote is available:
You may learn in a remote without having an already learnt-in remote. Please see “Overriding the Immobiliser” for more
information.
EMERGENCY PANIC / CAR FINDER FUNCTION
The panic / car finder feature is activated by pressing the
button on the remote control transmitter for
3
seconds
. This causes the indicators to flash (i.e. same as hazard lights) and the siren to sound. To cancel
“panic”, press the
button on the transmitter for
3 seconds
again.
Note
: Panic will not activate while the ignition is on by requirement of Australian Law (DECC).
BOOT (TRUNK) RELEASE (Optional connection by installer at extra cost)
This immobiliser is fitted with remote boot (trunk) release capability for vehicles with existing electric boot
(trunk) release. This feature enables the user to unlock the boot (trunk) by pressing the
button for
3
seconds
. The boot will unlock, and the immobiliser will disarm. NOTE: For safety reasons the remote boot
(trunk) release will not work when the ignition is on.
Note:
Boot release can be programmed to trigger instantly on pressing the
button.
Press
⁄
button
Press
⁄
Button
