RHINO GPD-40 Fence Pro, Руководство пользователя

Страница: 13 / 28

11
Visually inspect the color and amount of
grease inside the crankcase. There should
be a ring of grease collected to the wall in-
side the crankcase. Should the depth of the
ring from the wall inward measure 1/4"
(6 mm) or less
(Fig. 10)
this indicates the
grease is low. The maximum level should
not be more than 1/2" (12.5mm).
If the amount of grease appears to be low,
add a small amount of grease. Use only
Rhino approved grease (p/n 300500.)
DO NOT OVERFILL
GREASE AS IT CAN
DAMAGE THE DRIVER AND THE
HONDA ENGINE.
If the grease is discolored, very dark or
black, it should be removed and the post
driver needs further maintenance. This is
detailed in the section titled “Service of
the Hammer and Anvil.”
In the event of complete removal of old
and adding fresh grease
(Fig. 11)
the level
of grease should be to the bottom of the
crank pin. When the required service has
been performed in the crankcase, inspect
the o-ring seal and replace it on the crank-
case cover. Position the crankcase cover
on the GPD-40 Fence Pro
™
body carefully
to start the threads and once in the thread
groove, with your hand twist to the right
(clock-wise) until it is securely in contact
with the post driver body.
HAND TIGHTEN
ONLY. DO NOT
OVERTIGHTEN. Do not use tools, such as
a hammer or wrench, to tighten the crankcase
cover as it will damage the driver.
GPD-40 Fence Pro™ Service Instructions... continued
Fig. 9 -
Crankcase Cover
Fig. 10 -
If ridge of grease measures 1/4″
or less, add a small amount. At maximum
level it should measure 1/2".
Fig. 11 -
After completely cleaning out old
grease, add new grease till level with the
bottom of the crank pin.
!
WARNING
!
DANGER
!
CAUTION
IMPORTANT
NOTE
!
WARNING
!
DANGER
!
CAUTION
IMPORTANT
NOTE