Rhin-O-Tuff OD4000, Инструкция

Страница: 9 / 16

7
Providing power to the machine:
u
Power cord shall be certified for the country
where the machine will be installed.
Plug one
end of the power cord into the power cord
receptacle on the back of the machine. The
other end goes into the wall outlet.
Die Installation:
u
u
u
u
u
OD4012 Make sure the machine
is turned off before installing the die
Diagram 2.
.
Make sure there is no paper dust or paper chips
in the machine die slot before installing the die.
Install the die by sliding it into the opening
located on the left hand side of the machine. Make sure the punch pin
retainer slides into the slot on the backside of the opening.
Install die until right side of die is flush to exterior of right side of
machine.
Thread both retained die lock knobs into the die and tighten evenly
until the die can not move.
Diagram 2. (Image of OD4012)
! DANGER
Hazardous voltage.
Use only approved
power cord
assemblies.
!
WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.
Die Lock Knob
Punch Pin
Retainer