KF-50-OTM Instruction Book KF-50 Issue 1
Page 10 KF-50 Patent Pending
¾
2.3) KF-50e41 Mounted to a HD-e4100: See Fig. K.
Turn the HD-e4100 around so you see the rear of the machine as shown. With
the supplied Allen Wrench remove 6 screws (1) holding the Separator Rod (2)
and the Book Former (3). Remove the Separator Rod (2) and Book Former (3).
Move and Separator Rod down (4) to where the Book Former was mounted (3),
replace screws and tighten. Take the Book Former (3) and turn 180 degrees (5)
from end-to-end and locate where the Separator Rod was located (2). See Fig. K
balloon 6 for the correct final orientation of the Book Former. Center the Book
Former over the two available holes (7) ***, replace only the right end screws and
tighten. Continue past Fig. K to the next step for the left end screw.
*** Prior to Serial Number 1E01040 the second mount hole was not added. Call
Technical Support at 1-800-390-5782 for the HD-e4100/KF-50 Hole Kit. You will
need an electric drill and small clamp or small Vice-Grip® when you receive the
Kit.
Fig. K
See Fig. L. See the left end of the machine (1). Locate the #10 X ¾” Black Screw
and #8 Silver Washer (2). Using the Allen Wrench, install both the screw and
washer into the hole shown (2).
Fig. L