We are meticulous about maintaining a high level of customer service. However, warranty does not
mean free service.
Rhima Australia warrants their glass and dishwashers to be free from defects in material and workman
-
ship under "normal use and service", which does not include normal wear and tear or preventative
maintenance service.
Specifically not covered by warranty are service calls to adjust thermostats, rinse aid injectors, detergent
dispensers; commissioning or any other service requirement not strictly related to defects in material or
workmanship.
Rhima Australia will repair or replace any parts, which in Rhima Australia's sole judgement are defective
in material and/or workmanship. No responsibility will be accepted for repairs, defects or damages due
to improper installation, misuse or neglect.
The following conditions apply and if in doubt, please refer to our general terms and conditions;
1.
Warranty is 12 months on parts. In state capitals (within a
5
0 km radius of GPO) a 3-month warranty
on labour, to replace defective parts, applies. All other areas are not covered by labour warranty,
unless specifically mentioned in writing.
I
n any case, warranty repairs are only carried out within
normal business hours (Monday to Friday, 08.00-17.00 hrs, excluding public holidays).
2.
Travel & accomodation is not covered by warranty
.
3. All warranty call outs must be approved by Rhima.
4.
The following is expressly excluded from warranty claims:
•
Service or parts relating to drain pumps
•
Defects to dish racks
•
Service or parts relating to inlet and outlet hoses & solenoid valves.
•
Adjustments to temperatures, (water) levels, rinse aids, detergents etc
•
Incorrect use or incorrect installation
•
Any breakdown due to external influences (high or low water temperature/pressure, interruption
of electricity
s
upply
,
etc)
For full information on warranty conditions, please refer to our general terms and conditions, which are
available
on our website
www.rhima.com.au
.
EACH
APPLIANCE
HAS AN IDENTIFICATION NUMBER.
WARRANTY CLAIMS WITHOUT THIS NUMBER WILL NOT BE TAKEN INTO CONSIDERATION.
THE IDENTIFICATION NUMBER IS LOCATED ON THE LOWER RIGHT SIDE PANEL.
DATA PLATE
IPX3
MADE IN ITALY
Temperatura massima acqua in ingresso 60°C
Temperature max eau a l'entre
Maximale Temperatur Wasseranschl
Maximum Water temperature in-feeding
Pressione Dinamica alimentazione idrica
Pression dynamique arriveè d'eau
Dynamic pressure water supply
Dynamischer Druck asserreinlauf
Pressione dinamica vapore saturo
Pression dynamique vapeur satueèè
Dymanischer Druck gesattigter Dampf
Pression Dinamica Vapor Saturado
CL/Part
TECHICAL SPECIFICATION
500W
Model
S/N
Code DW 999XXYYYY
Model DESCRIPTION
S/N DW A 1015770
Type ..........
400V 3N 50HZ 8A
3500W
16A
200-500 kPa
WARRANTY PROCEDURES FOR RHIMA DISHWASHING EQUIPMENT
www.rhima.com.au
TAKING DELIVERY OF YOUR RHIMA DISHWASHING EQUIPMENT
Rhima Australia will not be responsible for any damages caused to the appliance during
its shipping to the customer. Please take note when recieving the appliance that it has not
been placed on its side or tipped over during transportation. Use the
TIP’N’TELL indicator
on
the outer packaging to see if this is the case.
It is
MOST IMPORTANT
that you take a photo of this
TIP’N’TELL indicator
and supply it
immediately to Rhima Australia if it was found that the appliance has been tipped and/
or dropped during transportation. We also advise that you take photos of any damage
caused to the packaging and the appliance and keep all the packaging so it can be
inspected by a Rhima representative.
3
