RHEONIK RHE26, Инструкция по установке и запуску

Страница: 8 / 44

RHE26/27 Installation & Startup Guide – Doc. No. 8.2.1.06 – Ver. 1.40 8
Figure 2: RHE26/27
Wiring with RHM
Connection Type TM
3.2.1.2 RHM Electrical Connection Type TM (PTFE Cable)
Table 4: RHE26/27 Wiring Plan for RHM Connection Type TM
1
The shield of the cable is connected internally to the housing of the RHM. If there is a
risk of a significant potential difference between the housing of the RHM and the PE
terminal of the RHE, the shield should be connected to the RHE PE connection via a 1nF
capacitor. Alternatively, a separate cable can be run for potential equalization between
the RHM case and the RHE and the shield left both unconnected and isolated at the RHE
or terminated to the PE connection via a 1nF capacitor.
Upon power up, if the RHE indicates an error and the temperature measurement on the bottom
right of the display shows “ -.--°C/°F ” please check the temperature measurement configuration
setting in the RHE (section 4.5).
The correct temperature measurement configuration setting for an RHM with connection type
TM is “7”.
Cable RHE2x Terminal
No. Wire Color Function No. Name
1 Brown Drive Coil high 1 DrvH
2 Blue Drive Coil low 2 DrvL
3 Red Temp. Sensor Pipe 3 PtP
4 Pink Temp. Sensors GND 4 PtG
5 Orange Temp. Sensor Torsion 5 PtT
6 Yellow Pick Up Coil A high 6 PkAH
7 Green Pick Up Coil A low 7 PkAL
8 Grey Pick Up Coil B low 8 PkBL
9 White Pick Up Coil B high 9 PkBH
10
1
(yel/grn) Shield 10 PE