Rheem RPVE Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 6 / 56

R e s i d e n t i a l S p l i t
R e v. : 1 3 M a r c h , 2 0 1 5
6
Equipment Selection
The installation of geothermal heat pump units and all
associated components, parts, and accessories which make
up the installation shall be in accordance with the regulations
of ALL authorities having jurisdiction and MUST conform to
all applicable codes. It is the responsibility of the installing
contractor to determine and comply with ALL applicable
codes and regulations.
General
Proper indoor coil selection is critical to system e ffi ciency.
Using an older-model coil can a ff ect e ffi ciency and may
not provide the customer with rated or advertised EER
and COP. Coil design and technology have dramatically
improved operating e
ffi ciency and capacity in the past 20
years. Homeowners using an older coil are not reaping these
cost savings and comfort bene
fi ts. NEVER MATCH AN R-22
INDOOR COIL WITH AN HFC-410A COMPRESSOR SECTION.
Table 1: Air Handler Matches for ARI Ratings
Compressor Section 025 036 048 062
Air Handler Model RHPL-HM2421 RHPL-HM3621 RHPL-HM24 RHPL-HM6024
Refrigerant HFC-10A
Metering Device TXV (Non Bleed) required
Air Coil
Type
Rows - Fins/in.
Face Area (sq. ft.)
N Style
2 - 16 fpi
5.7
N Style
2 - 16 fpi
5.7
N Style
2 - 16 fpi
8.55
N Style
3 - 14 fpi
9.98
Cabinet Con fi guration Up fl ow/Down fl ow/Horizontal (Multiposition)
ECM Settings
Comfort Control
System
Comfort Control
System
Comfort Control
System
Comfort Control
System
Fan Motor Type - HP ECM - 1/3 HP ECM - 1/2 HP ECM - 3/4 HP ECM - 3/4 HP
Newer indoor coils have a larger surface area, enhanced fi n
design, and grooved tubing. These features provide a larger
area for heat transfer, improving e
ffi ciency and expanding
capacity. Typical older coils may only have one-third to one-
half the face area of these redesigned coils.
Indoor Coil Selection - RPVS and RPVE
Split system heat pumps are rated in the ARI directory with
a speci
fi c indoor coil match. Matches with air handlers are
shown in Table 1. An ECM motor and TXV is required. Cap
tubes and
fi xed ori fi ces are not acceptable.
Air Handler Match-ups