Rheem GEN12AD-V, Руководство по установке

Страница: 23 / 88

23
Generator AC Connection System
A single-phase, three-wire AC connection system is used
in the generator. The stator assembly consists of a pair
of stationary windings with two leads brought out of each
winding. The junction of leads 22 and 33 forms the neutral
lead, as shown schematically and as wiring diagram.
A complete schematic and wiring diagram can be found later
in this manual.
NOTICE
Neutral is not bonded to ground at generator.
The conduit ( A ) between the corner electrical inlet and the
control panel is a UL requirement. If removed, it must be
replaced with similar conduit.
Grounding the Generator
Ground the generator per applicable codes, standards, and
regulations. The generator GND lug is located inside the
control panel door under the circuit breaker cover.
Utility Circuit Connection
i76UJMJUZwMFBETNVTUCFSPVUFEJODPOEVJU5IF
i76UJMJUZwMFBETEFMJWFSQPXFSUPUIFHFOFSBUPSTDJSDVJU
board, optional battery warmer and optional oil warmer. This
power also charges the battery. When power on these leads
is lost, the generator will start.
Using provided 2 pin connector plug and installer-supplied
minimum 300V, 14 AWG wire, connect each control circuit
terminal in the generator to the two-amp fuse terminals in
the automatic transfer switch.
When making connections, obey wire type and torque
specifications printed on the circuit breaker and neutral/
ground connector.
33
240V
11
22
44
120V
120V
11 22 44 0
To Transfer Switch
Power Winding
Ground Neutral
Line 2 Line 1
Neutral
Circuit
Breaker
Circuit
Breaker
A
NOT NO N
T
44 44
T
FOR FOR
O
11 11
FO
Ci i Ci Circui
Break
REPRODUCTION
ion on
TU CF CF SPVUFE SPVUFE
EFMJWFS FMJWFS QPXF QPX
attery warme attery warm
arges the bat arges the b
generator wi generator w
rovided 2 pin ovided 2 p
mum 300V, mum 300V,
rminal in the rminal in th
the automa he autom
When m When m
spec
spe
g
g
RE R