Rheem 340SS, Руководство пользователя и инструкции по установке, Страница: 44 / 52

LIGHTING THE WATER HEATER
44
LIGHTING INSTRUCTIONS
Using the gas control light the water heater as follows:
1. Stop , read the “Safety Information” on page 43.
2. Remove the access cover by lifting the access cover up and then pulling the
bottom of the cover away and down from the water heater.
3. Depress the gas knob slightly and
turn fully clockwise so the white dot
“

” (off position) faces the front,
aligning with gas knob position
indicator.
4. Wait five (5) minutes so any build-up
of unburnt gas can escape. If you
then smell gas, stop and follow “C”
in the “Safety Information” on
page 43. If you do not smell gas,
proceed to step 5.
5. Depress the gas knob slightly and
turn anticlockwise so the red star “
” (pilot position) faces the front,
aligning with gas knob position
indicator.
6. Depress the gas knob fully (until the red star disappears below the housing)
and after twenty (20) seconds, whilst keeping the gas knob depressed,
repeatedly press the igniter button (for up to forty (40) seconds) until the
pilot flame ignites. The igniter is a red button located below and to the right
of the gas control.
Warning: Keep your face higher than the gas control and clear of the
combustion chamber opening while pressing the igniter.
Note:
It is not possible to depress the gas knob fully if the gas control has
activated its safety shut-off feature. In this case, wait five (5) minutes for the
gas control to reset (this allows for any unburnt gas to escape).
7. Keep the gas knob depressed for a further twenty (20) seconds and then
release.
Release the gas knob and check the pilot is still alight - look through the
combustion chamber opening below the gas control.
If the pilot has failed to light or has not remained alight, turn the gas control
knob to the "

” (off) position and begin again at step 4.
gas control