10
5 TROUBLESHOOTING
5.1 LOCATING THE PROBLEM AREA
If the saw does not operate, the problem is either in the saw, the hoses, or the power supply. Locate the problem area as
follows:
1.
Stop the power supply.
2.
Disconnect the existing saw from the hoses and power supply.
3.
Connect a known working saw to the hoses and power supply. Refer to this manual for the proper hook-up
procedure.
a.
If the known working saw operates, the problem is in the disconnected saw. See the troubleshooting chart in
Section 5.2.
b.
If the known working saw does not operate, the problem is probably in the hose or power supply. Proceed to
Step 4.
4.
Stop the power supply.
5.
Disconnect the existing hoses from the known working saw and power supply.
6.
Connect a different set of hoses to the known working saw and power supply.
a.
If the known working saw operates with the different set of hoses, the problem is in the disconnected hoses.
b.
If the known working saw does not operate, the problem is in the power supply. See the power supply operating
manual for troubleshooting.
5.2 TROUBLESHOOTING THE SAW
The following chart is intended to assist with troubleshooting the TS14 Trenchsaw. While not all inclusive, the chart
outlines the most common causes of a problem and the recommended course of action.
The troubleshooting guide for the associated power supply is in the instruction manual specifically for this unit.
SYMPTOM CAUSE
CORRECTIVE
ACTION
Saw inoperative
Saw connected to improper
power supply hydraulic
system.
No hydraulic fluid in system
or fluid level low.
Saw parts loose.
Dirt or contaminants in saw
parts.
Saw parts worn or damaged.
See Chapter 2 for type of hydraulic system required. Verify
power supply hydraulic system.
Check fluid level. Fill to full mark. Check system for leaks.
Tighten component hardware.
Disassemble saw and clean parts.
Disassemble saw and replace worn or damaged parts.
Содержание TS14
Страница 16: ...14 Figure 6 1 TS14 Trenchsaw Assembly...