RGC PRO Drive E, Инструкция по эксплуатации

Страница: 19 / 27

14
7. Replace both cable access round caps.
Figure 6-3.
PRO DRIVE BRAKE/CLUTCH CABLE ADJUSTMENT
6.10 PRO DRIVE BRAKE ADJUSTMENT
1. Lower platform completely and shut off PRO DRIVE. Turn off gas supply, or disconnect from electric power supply.
2.
Refer to Figure 6-3. Remove the two cable access round caps (B/N 8) from the drum guard (B/N 7) by depressing the
cap release tabs located inside the guard.
3.
Ensure that both Brake/Clutch cables (B/N 6) are not tensioned. If they do not easily move with light finger pressure
loosen the nuts at the bottom of each cable using two seven-sixteenths open-end wrenches and back off both of the
upper nuts several turns.
4.
Refer to Figure 6-4. Measure the length of the compressed brake spring only (B/N 11), located on the back of the
brake differential (B/N 9). The spring length should be three and seven-eighths inches long.
5.
If the spring requires length adjustment, use a nine-sixteenths open-end wrench on the bolt head and a nine-sixteenths
open-end wrench on the locknut to turn the nut until spring is at it’s correct length.
6.
Readjust the Brake/Clutch cables as described in section 6.9 (Brake/Clutch Cable Adjustment).