8
To
configure and activate the stopwatch/timer function,
you should:
1)
Call the configuration menu, by pressing the
MENU
key.
2)
Select the
F14
function using the
↑
and
↓
keys and confirm it with the
→
key.
3)
Using the
↑
and
↓
keys, select a particular special function of the clock and confirm it with the
→
key.
STO
Stopwatch
tiUP
(
Timer Up
)
timer counting up from 0 to the preset value,
tiDO
(
Timer Down
)
timer counting down from the preset value to 0
4)
After selecting the
STO
(stopwatch) function, press the
A
key to start counting.
5)
After selecting the
tiUP
or
tiDO
function (timers), you should set the value to/from which the timer is supposed to count.
Setting the particular value on the hour/minute/second position is done using the
↑
,
↓
and
→
keys.
6)
After configuring the selected timer mode, press the
A
key to start counting.
7)
Functions of the keys:
•
A
– stop the counter/restart counting,
•
B
– erase the counter (active only when counting is stopped),
•
←
– return to the F14 menu.
8)
Range/resolution dependent on the clock type:
•
ZAXX
: maximum value 99:59
(Minutes:Seconds)
•
ZBXX
: maximum value 99:59:59
(Hours:Minutes:Seconds)
NOTE!
Timer settings begin from hours for the clocks of the ZBXX type and from minutes for the clocks of the ZAXX type.
NOTE!
After exiting the F14 menu, counting is active in the background – after re-entering the previously selected function,
the current counter value will be displayed regardless of the state (counting, stop).
NOTE!
Activating any function such as counting, exiting the F14 menu and re-entering the F14 menu and selecting another
function will stop counting and cause erasing the counter.
NOTE!
Setting the timer counting values is possible only when the timers are stopped. In addition, setting the counting value
to 00:00 or 00:00:00 (depending on the clock type) causes looping and resetting the counting value – protection
against the 0 setting.
NOTE!
Resetting the counter is possible only after having it stopped, otherwise pressing the
B
key will cause no action.
NOTE!
When the selected timer finishes counting, the relay will be activated for 2 seconds. After deactivating the relay,
recounting with the same settings starts after pressing the
A
key.
NOTE!
After pressing the
→
key in the F14 menu, the name of the latest set function will be displayed, and, if no function has
been set/activated before, the selection will begin from the stopwatch function
"STO"
by default.
To
do a hardware restore factory settings of the clock,
you should:
1)
Disconnect the device from the power supply.
2)
Make sure that the GPS connector cable is not connected (disconnect if there is).
3)
Connect the GPS pin to GND pin inside the connector.
4)
Switch on the power.
5)
Wait (about 3 seconds) until the clock signals reset by flashing of middle-segment digits.
6)
Disconnect the GPS pin and GND pin inside the connector
NOTE!
This function is used to fully restore factory settings, including resetting the alarm and making the default network
configuration. This function doesn't reset a remote control codes. When the device is equipped with LAN module the
network settings will be reset as well.
Содержание ZA series
Страница 7: ...7 ...
