10
Appendix A: Supporting the “Website”
The ZA, ZB and ZAH, ZBH series clocks
equipped with the network communication module (Ethernet module) allow intuitive
configuration through the built-in “Website”.
To configure the network connection, follow the document
Network Card Configuration Manual
, to be downloaded from the following
website:
http://rgbtechnology.pl/soft/
1.
Connection with the device
The connection with the device is made through the Ethernet interface, while supporting the integrated „Website” is done via the
Internet browser (recommended browser: Mozilla Firefox, version 16.0.2 or later).
To connect with the device, enter the IP address assigned to the device into the browser (default:
192.168.0.11
).
Then, the device will ask you to enter: username and password (default User:
admin
, Password:
dbps
).
Note!
If you include a few clocks to the same network, the devices must be connected in succession and given a unique IP address,
which will avoid an address conflict (initially all of them have the same default IP address).
2.
Supporting the “Website”
The integrated “Website” consists of five webpages which allows you to configure various functions of the device.
NOTE! Always confirm the changes of the settings of the device parameters with the "Save" button.
2.1.
Time tab
This tab allows you to configure the parameters connected with time.
•
Local date & time
– manual setting of the local time and date.
•
Remote time synchronization
– configuration of the remote synchronization of time, of the time zone, of allowing for daylight
saving time, and of the IP addresses of NTP time servers.
•
Local Time synchronization
– configuring time synchronization (the time source, the time zone, the daylight saving time, the IP
addresses of time servers, the Master Mode).
Note!
To make the time synchronization using the NTP servers work, you need the proper (taking into account local network
addresses) configuration of the following parameters: "IP Address", "
Subnet mask", "
Gateway" in the
Advanced
tab and the
connection of the device to the Internet.
2.2.
Display tab
This tab allows you to configure the parameters connected with the device display.
•
Format
– configuring the displayed functions and their duration (the clock, the date, and the thermometer) and the date
format.
•
Brightness
– configuring the display brightness and activating the automatic brightness control.
•
Eco
– setting the energy saving mode (the time of activating the device, the time of deactivating the device).
Содержание ZA series
Страница 7: ...7 ...
