The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V.
RefGuide_U-routerNGW_v1.01.docx
Page: 27(
57)
In the screenshot below, the communication settings have been set to communicate with a Cisco
console port over USB.
Figure 19 Configuration Settings for the Cisco USB console interface
Please note:
The USB console port of a Cisco device requires the 5V supply voltage to be
present on the USB-B connector. If the 5V supply voltage is switched off the port does not enumerate
and the Cisco device will revert to RS232 console output.
During reboot of the Cisco device the USB serial port will temporary disappear from the system since
the USB port is also restarted. The U-router NGW will probe if the USB port re-appears and then re-
connects your terminal session with the USB port.
