DSFIREFLY-3a August 08
©
2008 REG No 277 4001, ENGLAND.
Page 5
F
IRE
F
LY
F
IRE
B
LADE
R
ADIO
R
EMOTE
C
ONTROL
S
YSTEMS
Technical Specifications
Transmitters : FireFly, FireBlade
Enclosure Rating:
Standard
IP40 (TBC)
With IPKit
IP65 (TBC)
Battery Type:
CR2032 (supplied)
Dimensions:
90 x 54 x 27 mm (Note: FireBlade is supplied with external Antenna)
Electrical Characteristics
Min
Typical
Max
Units
Supply Voltage
3V
V
Supply Current
mA
Frequency: FireFLY:
Wideband
FireBLADE:
Narrowband
432.90
434.450
433.920
434.525
434.10
434.600
MHz
RF Output Power (ERP) @ 433 MHz
-
3
10
mW
Receiver Decoder
Enclosure Rating
IP68
Storage Temperature:
-10 to +70
o
Celsius.
Operating Temperature:
0 to +55
o
Celsius.
Dimensions
169 x 132 x 85mm (not including antenna)
ELECTRICAL CHARACTERISTICS
MIN
TYPICAL
MAX
DIMENSION
Supply Voltage for +12 v
10
12.0
16
Vdc
Supply Voltage for +24 v
22
24.0
28
Vdc
Supply Voltage for 230Vac
230
Vac
Relay Rating* (230Vac) RLY1-4
5
12
A
Supply Current : Quiescent
All relays operating*
16
140
mA
Time delay from Tx on Switch to Rx Relay operation
100
mS
Time delay from Tx sw relax to Rx Relay release
300
MS
*The relay contacts in this unit are for functional use only and must not be used for isolation purposes
Notes on FCC and CE approval.
1. Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
2. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
3. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
