Reznor ACT03, Инструкция по установке и эксплуатации

Страница: 7 / 10

4. Electrical Connections
4.1 Electrical Connections
These units are suitable for connection to a 230/240 Volt 50 Hz single phase supply.
The appliance shall be connected to the supply via an appropriate switched fused
double pole isolator having a contact separation of greater than 3mm. Test for correct
operation and refit the cover.
For connection to the mains supply it will be necessary to open the terminal cover at
the side/back of the unit to connect the supply from the controls prior to refitting the
cover. Wire in accordance to the wiring diagrams.
For safety reasons, a sound earth connection must always be made to the unit before
it is put to use. The unit should be wired in accordance with IEE Regulations for the
Electrical Equipment of Buildings.
4.2 Electrical connections for RX models
Fig.8 Heater with terminal cover open
Fig.9 Terminal cover detail
Page 7