Reznor ACT03, Инструкция по установке и эксплуатации

Страница: 6 / 10

Fig.1 Air discharge of ACT03 – RX and ACT04 – RX
Fig.3 Mounting supports
3. Installation Details
3.1 Mounting
The Reznor recessed ceiling heaters are designed to fit in place of a standard
600mm ceiling panel.
It is essential that the ceiling frame is adequately supported to support the weight
of the heater, or that the heater is individually supported. There is provision on the
heater for chain or wire, support or mounting.
•
The weight of the ACT03 – RX, ACT04 – RX is 7kg
•
The weight of the ACT06 – RX is 10kg
It is the sole responsibility of the installer to ensure that the points of attachment to
the building are sound. Care must be taken to allow complete free air movement
into the inlet grilles of the unit to ensure the correct working operation of the heater.
Carefully unpack the unit.
The unit is supplied with a length of self–adhesive foam strip. This can be cut into
lengths and is to be laid on the 4 sides of the ceiling frame. This will ensure that the
unit assembly is free from vibration. The discharge grille and diffuser assembly can
now be fitted into the ceiling frame.
Fig.2 Air discharge of ACT06 – RX
The wire or chain used to mount the
heater can be attached to 4 of the M6
studs or the 4 x M6 threaded inserts as
shown in diagram.
Ensure the air outlet of ACT03 – RX and ACT04 – RX is
nearest to the wall or corner.
Top or side cable entry
Terminal cover
Page 6