11
INSTALLING INSTRUCTIONS
1.
Check the fuel and water levels.
2.
Connect the power cord to the power socket and press the Reset switch on the plug to connect power
to the heater.
3.
Press the “Power” button. Once the heater has been activated, the “Burn” indicator (3) is lit.
4.
Use the temperature control buttons (6) to set the desired temperature.
5.
The diesel burner is deactivated once the desired temperature is reached. It is restarted once the
water temperature drops 2 or 4 degrees below the set target temperature.
- Turn off the heater using the POWER button.
- Hold the DOWN and UP buttons simultaneously for 5 seconds.
- Di F2 or F4 will flash on the screen.
- Choose the amount of degrees the water temperature is allowed to drop before the heater
restarts with the DOWN and UP buttons.
- Finally, press the POWER button to lock your selection.
6.
Deactivate the water heater by pressing the “Power” button again.
WARNING!
The heater must always be prevented from water splashing into the heater.
Please take this into account during installation and use!
NOTE!
The heater operating voltage is 230 V~, 50 Hz. It is the responsibility of the user to
connect the device to a power grid that supplies the appropriate voltage.
NOTE!
Do not turn off the heater by pulling the power plug out of the socket.
NOTE!
Always deactivate the heater before refuelling it.
RECOMMENDATION :
Use only high-grade biodiesel, diesel or red diesel in the heater. Always
ensure the cleanliness of the containers used for refuelling the
heater. Container impurities and the use of fuels other than diesel
may cause malfunctions or excessive soot formation.
RECOMMENDATION :
When handling fuel, observe all relevant safety instructions.
