Revv Owner’s Manual - 25
1)
The front panel toggle switch, when held for 2 seconds will toggle the
loop in & out. This method of toggling the loop is designed for footswitch
preset setting (See 7.1) but can be used for FX Loop in/out toggling as the
user requires from the front panel of the amplifier when the footswitch is
not plugged in. Note: When the FX Loop in/out is toggled from the front
panel by holding the switch, the LED will flash 4 times when it is in, & 3
times when it is out of the signal path.
2)
The foot switch, when not in preset mode, toggles the effects loop in &
out of the signal path when the FX Loop is turned on & button #5 of the
footswitch is pressed. The footswitch LED #5 will illuminate when it is in, &
turn off when it is out of your signal path.
3)
The FX Loop can also be controlled via MIDI & CC commands from
external equipment. Simply program the amp for MIDI programs or use
CC commands to do so. (See Section 6)
FX Loop Hook up
First, you need to hook up your effects units to the amplifier. The send
jack will need to be connected to the input of the first (or only) effects unit
in your chain. The out jack on the effects unit (or last pedal in your chain)
will then connect back to the return jack on the amp.
Next, turn on the amp & turn the effects loop on by pressing the FX Loop
toggle switch up on the front panel. You should see the red LED light up
to indicate that the effects loop is now on & in the guitar signal path.
Adjust each channel’s level control to your liking & set your send level
control & master volume as above.
Note: If you hear no sound - your effects loop level control knob is proba-
bly set at zero!
4.4
