Revv Owner’s Manual - 5
set up & power up
Only keep your Revv in a dry place that keeps 6” of space between the
rear and any other objects. Tubes produce heat, and anything flammable
should be kept away.
First, make sure that the power and standby switches are in the off (down)
positions. Next, connect the AC power cord to the amplifier Mains con-
nector on the rear of the amplifier - then to an AC outlet. At this point, all
other peripherals can be connected to the amplifier as well: Foot Switch,
FX Loop, Guitar, and cable
Note: A high quality, shielded instrument cable is recommended for guitar
input as well as FX loop connections to prevent unwanted noise.
Once all your connections are made, move the power switch to the On
position and give the tubes at least one minute to warm up. Now is a great
time to begin setting all controls while we wait. We recommend setting
the master volume, channel level, and gain controls to the lowest setting
or zero (fully counterclockwise) and all treble, mid and bass controls to the
12 o’clock positions to begin. Now set the standby switch to the Revv (up)
position and you are ready start!
Note: Upon power up, you will notice that all LED’s light up for a couple
seconds and then only the Channel 1 LED remains lit. This is normal as the
amp does a start up sequence at power up, then arms channel one to
begin.
1.1
