Revv Owner’s Manual - 31
MIDI Channel Setting
This amplifier can either automatically or manually change the 16 MIDI
channels you would like it to respond to. The channel change is stored in
memory & only needs to be done when you need the amp to respond on
a certain channel.
1)
In order to set the MIDI channel:
With the power off, press & hold the store switch then turn on the power
switch. The amp will power up & begin to flash all 3 channel LEDs. Once
this happens it is awaiting the channel data to be received from the exter-
nal equipment (Automatic) or to be set manually.
2a)
To set the channel automatically: (recommended)
With your external equipment ready (pedals, computers, etc.) & set to
the channel you want the amplifier to be controlled from via MIDI, send a
command to the amplifier by pressing a program change button or CC
command on your external equipment. Once the amplifier receives the
data, it will verify the channel it received & save it to memory. Easy!
2b)
To set the channel manually:
Once step 1 has been completed above & the channel LEDs are flashing,
press the CH1 CLEAN toggle switch (up). The CH1 LED will flash & the
other Channel LEDs will turn off, this signifies that MIDI channel 1 has
been selected. Simply continue to press the CH 1 toggle switch (up) to
get to the channel you desire. As you press the switch you will notice the
other Channel LEDs turn on as you increase the MIDI channel number.
Once you reach the channel you desire, press the STORE switch to save
it to memory.
6.2
