1795 N. Lapeer Rd., Oxford, MI 48371 T
– 763 424 3702 E – [email protected] rvlti.com
Copyright 2016 Revolution Lighting. All rights reserved.
IN072_01_20160928
Page 3 of 6
1.
Remove the previous light fixture(s) and dispose of properly. Make certain that any existing hardware that is to be reused is
adequate and secured properly to support the new fixtures. The conduits need to be tight and must not be able to twist in place.
2.
Standard Billboard (14’ x 48’) mounting: Position the Round or Square conduit underneath the crosswalk of the Billboard as shown
in Figure 1 and secure with U-
Bolts firmly to ensure they will support the weight of the fixture. Each pipe should be 9’ from the
center of the Billboard, 3’ down from the bottom of the Billboard, and a distance of 5’ from the face of the Billboard. If existing
hardware is reused you may need to relocate or replace components for proper alignment.
3.
Now that the conduit is in position, attached the supplied fixture plate onto the conduit as shown in Figure 2.
