Revolabs Solo Executive, Инструкция по установке и эксплуатации

Страница: 9 / 16

7
7 7
7
Microphones in new systems come paired to the Base Station with each microphone assigned to
a unique channel on the base unit. However, if a replacement microphone is ever required, it will
need to be manually “paired.”
If a microphone is lifted from the Charger Base and the LEDs continuously flash alternating Red,
Green and Yellow, and the Base Station LEDs flash alternating Red and Green, the microphone
needs to be paired to the system. Make sure that all other microphones are properly paired, and
that the Base Station is powered on, before proceeding to pair an individual microphone. By
noting which microphone channels are already in use (paired), it will be obvious which channel to
use for pairing the microphone.
Microphone Pairing Instructions
1. First make sure the microphone is turned OFF (no LED activity). If the unit is ON, press and
hold the MUTE button for 10 seconds until the LED turns solid RED (do not release when you
hear two beeps), to turn the unit off, if needed.
2. Next, place the microphone unit into pairing mode by holding the
MUTE button down for six
seconds. The LED will turn solid GREEN and then solid RED. Release the MUTE button. The
microphone unit is now in pairing mode.
3. Within one minute, push and hold the button for the desired channel on the Base Station for
six seconds to enter into pairing mode. The LED for that channel will be solid RED until pairing
starts, as indicated by a quick GREEN flash switching to flashing RED on both the microphone
and the Base Station.
Pairing Charger Base to Base Station
“Pairing” is also used to create a link between the Charger Base MUTE control and the Base
Station. When the Charger Base and Base Station are paired, the system mute function may be
used.
The Charger Base in new systems come paired to the Base Station. However, if a replacement
Charger Base is ever required, it will need to be manually “paired.”
System Mute Button Pairing Instructions
1. First, power-on the Charger Base and Base Station (power LEDs on both units are GREEN).
2. Next, place the Base Station system into pairing mode by briefly pressing the LEARN button on
the rear connection panel. The pairing LED next to the LEARN button will illuminate.
3. Now press the
MUTE button on the Charger Base once. The pairing LED on the back of the
Base Station panel will go off and the power LED on the Charger Base will turn solid RED.
4. Press the
MUTE button the Charger Base again. The pairing LED on the Base Station will flash
twice and the power LED on the Charger Base will turn solid GREEN.
5. Once the pairing LED on the Base Station stops flashing the
MUTE button on the Charger Base
will mute all the microphones in the system.