11
If more than one of the DIP switches 3 – 6 is in the ON position, unwanted and
unpredictable microphone mute behavior will be observed and audio
distortions will be experienced.
In Push to Mute mode, the microphone send audio data, unless the button is
pressed, at which time the microphone will mute.
In Push to Talk mode, the microphone is muted, unless the user presses the
button, at which time the microphone sends audio data until the button is
released again.
In Toggle mode, the microphone is muted or unmuted, changing its state each
time the button is pressed.
Factory preset
Factory preset for the DIP switches is on local control, red LED light indicates
mute, mute toggle starting unmuted.
Switch Position
Mode
1
2
3
4
5
6
Local Control, Mute
Toggle, start unmuted
OFF
ON
OFF
OFF
OFF
ON
Audio wire connection
Connect the red wire to the positive (+) microphone input of the DSP or audio
equipment you use with the microphone. Similarly, connect the black wire
with the negative (-) input of the DSP. When connecting to a male XLR
connector, use the following polarity:
1 – Ground / Shield
2 – Positive (+)
3 – Negative (-)
