REVERSO-MANUFACTURING DV200 NG/RV, Инструкция по установке и эксплуатации

Страница: 17 / 29

17
INSTALLATION OF LOG SET (Standard Set)
Log Set: Four pc. (4) - Two top (cross logs)
- Two bottom Ceramic Fiber logs An optional fifth log is available, for the Top
Vent models.
The log set for the DV200 is shipped in the master carton. Check to ensure there is no damage to
any of the four (4) logs. It is very important to install these logs in their proper position to insure
safe operating conditions. (SEE THE FOLLOWING LOG PLACEMENT DIAGRAM)
WARNING: Dangerous operating conditions may occur if these logs are not positioned in their
certified locations.
1. Open the front door.
2. Remove logs carefully from their packing.
3. Place rear fiber log on rear log holder.
4. Place front fiber log on front log holders. The front bottom notch will match with the front burner.
5. Place the two cross logs on the positioning notches provided and according to the diagram shown
above.
INSTALLING THE GLOWING EMBERS
CAUTION: Use only the amount (0.5g with rear vent and 1.2g with top vent) and type of ember
material supplied with this appliance. The use of other foreign materials on the burners can
create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement, contact your
nearest REVERSO dealer for an approved replacement embers kit.
1. Gently remove the ember material from the plastic bag.
2. Spread these pieces evenly across the front ember tray. Place a single layer of embers on top of
the front burner, under the front log.