- 45 -
3.7. Settings device parameters
Important device parameters can be entered from the screens. To change all parameters of the device in a convenient way connect the USB cable to
the device (you can left usb cable led out in car in an accessible place) and run the UTCOMP application on your PC. How to run and manage the
program is explained in Section 3.1.
From the application you can change all device settings. There are few groups of settings:
o
configuration parameters,
o
user preferences,
o
screen settings,
o
inspection/service settings,
o
alerts configuration,
o
advanced settings.
All important settings are stored in non-volatile memory, so after a power failure (disconnected from battery) UTCOMP does not lose these settings. A
copy of configuration is done for each turning off ignition.
3.7.1. Configuration parameters
The most important group of settings related to the configuration of the vehicle. Without proper configuration, performance of certain function may
be incorrect.
In this group you can change the following settings:
•
engine type (fuel type + number of cylinders),
•
type of fuel consumption signal (PWM/FREQ ground-controlled or plus-controlled),
•
vss and injection constants (if car is equipped with LPG then injection constant is different for PB and for LPG - usually the injection constant for
LPG is 10-20% higher than the injection constant for PB),
•
tank capacity (enter the actual volume, which you are able to refuel),
