- 11 -
2.
Assembly manual
IMPORTANT:
Read the following instruction before installing UTCOMP. The warranty does not include damage caused by improper installation.
2.1. General remarks
UTCOMP-3 has a 24-pin MOLEX connector. UTCOMP-PRO has a 24-pin and 12-pin MOLEX connectors. The kit comes with a plug with cables to solder.
Pay special attention to the numbered pins
. All cables used to be install must be the dedicated automotive (FLRY), recommended 0.35 – 0.5 mm
2
cross-section with insulation resistant to mechanical damage (abrasions, cracks etc.). All connections must be effectively soldered and hotair shrink
insulation (unconnected wires too). First you need to solder all the needed wires to the pins, and only then connect the plug to the socket device.
Before the first connecting plug to the device, make sure that the appropriate signals have been soldered to the corresponding pins of
the plug.
Connect the LCD/OLED display before connecting the 24-pin connector.
