5
B10 Subwoofer
Owner’s Manual
Rooms with multiple seating rows
Placing one subwoofer in a front corner and the other subwoofer in the
rear corner on the same side will produce the most consistent bass
performance throughout multiple seating rows.
Video Screen
PLACING A SINGLE SUBWOOFER
When installing a single subwoofer, be prepared to experiment with
different locations to find the one that produces the best results
throughout your room’s seating area. As in the previous examples,
placing the subwoofer in a corner will produce the fewest number of
deep response dips, which cannot be corrected with equalization.
Video Screen
Since listening and speaker locations are equally important, the
trial-and-error process can be time-consuming. However, the sonic
rewards are well worth the time spent determining the ideal placement
locations. Remember that peaks (below the subwoofer crossover
frequency) can be minimized or eliminated by the proper adjustment of
the Concerta 2 B10’s Equalization controls, but dips cannot be corrected
via equalization. Therefore, the most important objective is to find
locations that result in the minimum number (and severity) of dips.
Contact your authorized Revel dealer for assistance in determining the
proper placement of your Revel loudspeakers and subwoofers.
After placing the B10 subwoofer(s), begin playback of a familiar music
or film source that has substantial bass content. Listen from the primary
listening position, increasing the overall volume of the system to a
comfortable level. Adjust the Subwoofer Level (volume) control until
you obtain the desired blend of bass. Also, test the subwoofer level by
playing a recording of a deep male voice. Setting the subwoofer level (or
crossover frequency) too high results in unnaturally “thick” or “boomy”
vocal reproduction. Bass response should not overpower the room, and
should be adjusted to achieve a harmonious blend across the entire
audible range.
If you are using a multichannel receiver or processor with a subwoofer
output, it’s preferable to use the Subwoofer Level adjustment on the
processor. Set the B10 Level control to the indicated “LFE” position.
NOTE: Setting the level of the subwoofer in relation to the left
and right front speakers is of critical importance because it is
essential that the subwoofer integrate smoothly with the entire
system. Setting the level too high results in an overpowering bass
response. Setting the level too low negates the benefits of the
B10 subwoofer.
Содержание CONCERTA 2 B10
Страница 1: ...B10 Subwoofer Owner s Manual...
