6
B10 Subwoofer
Owner’s Manual
MAKING CONNECTIONS
CAUTION: Never make or break connections unless all
system components are powered off.
ATTENTION: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR.
AC 100-120V ˜ 50/60Hz 1500W
FUSE RATING: 115AL 250V
Figure 8: Rear-panel input connectors
The B10 subwoofer input connectors are located on the rear panel.
Some processors incorrectly label the subwoofer output as LFE; others
offer both an LFE and a Subwoofer output. If there is no labeled
subwoofer output, use the LFE output. If the output has labeled
connections for both LFE and Subwoofer, use the Subwoofer output.
The L (Left) and R (Right) connectors on the rear panel of the B10 can
be used with 2-channel applications, where there is no dedicated
subwoofer output available. These inputs are can be crossed-over by
the adjustable Low-Pass Crossover control on the rear panel. Having
the low-pass filter enabled helps offset the fact that most 2-channel
systems do not perform any high-pass filtering on the main speakers,
minimizing the advantages of using a subwoofer.
2-CHANNEL APPLICATIONS –
CONNECTING TO THE MAIN OUTPUTS
Receiver/Preamplifier
B10 Input Panel
Main
Outputs
Connection to main outputs
1. Connect an RCA patch cable between the left main output on the
receiver/preamplifier INPUT connector on the B10 rear panel, as
shown in Figure 10.
2. Connect an RCA patch cable between the right main output on the
receiver/preamplifier INPUT connector on the B10 rear panel.
NOTE: This configuration applies to receivers with preamplifier
outputs or to preamplifier/power amplifier configurations in which
there are two sets of Main outputs. If the receiver has jumpers
from the Pre- or Main-Out to the Amp in connectors or if the
preamplifier has only one set of Main-Out connectors, a
Y-adapter should be used to send the same signal to both the
main power amplifier and the subwoofer(s). Tape Out or Record
Out connectors cannot be used.
Содержание CONCERTA 2 B10
Страница 1: ...B10 Subwoofer Owner s Manual...
