Reva G-Wiz, Руководство пользователя

Страница: 73 / 100

8.6 Windscreen Washer & Wiper
WINDSCREEN WASHER
The windscreen washer fluid tank is
located under the hood on the left-hand
side corner. Check the washer fluid in
the tank at least once a month. Top up
the fluid as and when necessary.
Absence of windscreen washer fluid can
damage your washer motor. It is
advisable to always keep the washer fluid
topped-up.
Maintenance
WIPER BLADE
REPLACEMENT
Contamination of either the windscreen
or the wiper blade with foreign matter
can reduce the effectiveness of the
windscreen wiper. If the blades are not
wiping properly, it could be time to
replace the wiper blade. To replace the
wiper blade press the retaining clip and
pull the blade off the arm & push the
new wiper blade into the arm.
Use “anti-freeze” solution in the
windscreen washer reservoir. This
will help water in the Washer unit
not be frozen.
WARNING
Damage may result if the washer
motor is operated whilst the fluid is
frozen or with no fluid in the
washer reservoir, or in case nozzle
is blocked
CAUTION
72
8.5 Power Pack
Maintenance
Before topping the ower ack
, ensure that it is fully
charged. lace the “distilled water can”
at a height of
feet above the
level of the ower ack. Flip open the
lid of the onboard charge port on the
side of your ar. Pull the ring of the
quick release connector back. Insert it
into the battery water inlet located
below the charge point in the on-board
charger.
Release the ring. At this point, you will
hear a click indicating that the system is
secured. The distilled water should start
flowing into the power pack, indicated
by the small revolving fan, acting as a
water flow indicator inside the vacuum
nozzle. Check the tube for proper flow
of water.
p p with
“distilled water”
P
5½' - 6'
p p
c
The watering process will take 2-5
minutes, depending on the water level in
your power pack. When full, the flow
indicator will stop revolving indicating
that the power pack has stopped the
intake of water. Hold the water flow
indicator on a flat surface to check the
flow of water. To disconnect the
watering system, turn the water outlet
off, pull the ring of the quick release
connector back and gently remove the
tube connection by pulling the tube
from the water inlet pipe.
5½' - 6'
Never topup the power pack with
battery water unless your car is
fully charged.
Never topup the power pack
while charging is in process.
Topup the power pack within 3
charging cycles after the battery
water light comes on. Not doing
so will turn ON the Low water
light permanently. This will also
affect the performance of your car
and your power pack warranty.
Use only demineralised water, else
the warranty on power pack will
be void.
CAUTION
71
Downloaded from www.Manualslib.com manuals search engine