REV Midwest Automotive Design American Coach Patriot 2022, Руководство пользователя

Страница: 146 / 178

A M E R I C A N C O A C H P A T R I O T O W N E R ’ S M A N U A L
A M E R I C A N C O A C H // P A T R I O T S E C T I O N 1 3 // 1 4 4
STEP 3
Keep the remote control clean� If necessary, wipe it
with a damp cloth;
STEP 4
Remove AA batteries prior to non-use and extended
storage times�
STEP 5 Polish the cover hood with a soft cloth; and,
STEP 6 Apply an even layer of silicone on the seal�
REMOTE CONTROL BATTERY REPLACEMENT
The roof fan remote control requires two AA size batteries to operate�
Please refer to the image below when replacing the batteries�
Follow these steps to replace the remote control batteries:
STEP 1
Open the cover of the battery compartment on the
back of the remote control;
STEP 2 Replace the old batteries with two new AA batteries;
STEP 3
Make sure that the positive and negative terminals of
the batteries correspond to the positive and negative
markings in the battery compartment;
STEP 4
Close the battery compartment, place the alignment
tab into the square hole on the back of the remote
control; and,
STEP 5
Press the lid of the battery compartment down until the
catch clicks into place�
The following lists the FANTASTIC roof mounted ceiling fan’s
specifications. Please refer to this information to keep your fan
operating properly.
SPECIFICATIONS
FanTastic Vent Model 7350 Model 2250-7300
Voltage 12 Volts 12Volts
Max. power
consumption
30 Watts 36 Watts
Noise level < 40 dB(A) < 40 dB(A)
Dimensions WxDxH 471x471x190 mm 471x471x190 mm
Weight 11.2 lbs. (5 kg) 11.2 lbs. (5 kg)
WARNING
Only operate the FANTASTIC roof fan when the grille ring is
warning
fitted. Touching an un-guarded fan can cause damage to the
equipment and may result in a serious physical injury.
VENTLINE VANAIR ROOF VENT (BATH FAN)
The Ventline Vanair Roof Vent with the 12-volt fan was designed to
be maintenance free�
To ensure the fan is operating and venting
efficiently be sure to follow cleaning procedure listed in this section.
STEP 1
Clear the area under the vent fan of anything to
prevent any dust or dirt from falling on them;
STEP 2
Put on safety glasses to protect your eyes from dirt or
dust falling in them;
STEP 3
Remove the two screws that secure the pull-down
handle;
STEP 4 Remove the two screws that secure the vent’s screen;
STEP 5 Remove the thumb nut securing the switch;
STEP 6
Gently remove the screen� Rinse the screen and
thoroughly dry it; cleaner – with non-abrasive
detergent and warm water – in a dishwasher;
STEP 7
Wipe the fan blades with a dampened lint free micro
fiber towel; and, dry, you can apply a waterbased
protective agent and polish the grille ring and fan
blades to a high gloss� This reduces dust and dirt
deposits and makes cleaning easier; and,
STEP 8 Reverse the process to reassemble the unit�