REV Ritter L2699, Руководство по сборке и эксплуатации

Страница: 10 / 20

10
GB
TECHNICAL DATA
• Ambient temperature: 0°C – 25°C / max. 25°C
• Do not expose the product to direct sun and shield it from extreme heat!
• Nominal values: 230V~; 50Hz
• Allow the luminaire to cool down sufficiently!
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• LED service life: 25000h
MAINTENANCE
• Illuminant: 288 LED´s
CLEANING
FUNCTION
• Colour rendering index (Ra/CRI): ≥ 80
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Instructions
• IP protection class: IP20
• The light source of this luminaire is not replaceable; if the light source has reached the end of its service life, the
entire luminaire must be replaced.
• Output: 50W LED
• Supply line: 1.8m H05RN-F 3G1.0mm²
• Socket of the supply line: protection class IP44
• To avoid damage, do not bend or knot cables over sharp edges or corners!
• Colour temperature: 6500K
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Product
• Beam angle: 360°
• Remove all dirt from the housing or protective panel immediately, as this can lead to overheating.
• Do not operate the product at, on or in the vicinity of open flames (e.g. candles)!
• Luminous flux: 5500lm
• Disconnect the product from the power supply and secure the circuit from being switched on again.
• Switch off the switch and turn the dimmer to „Off“ before putting the luminaire into operation.
• Insert the plug into a 230V~ mains socket with a protective contact.
• Switch the switch on and turn the dimmer to the desired brightness.
• Turn the dimmer to „Off“ and turn the switch off when you no longer need the luminaire.
Note: If you only turn the dimmer to „Off“ but leave the switch on, the luminaire will continue to consume electricity.
• For installation/application options, see A2
SCOPE OF DELIVERY
• Energy efficiency class: A+
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
• Protection class: I (S9)