21.11.2001
Retsch GmbH
17
Doc. No E98.014-016.9999 A
Vibration height
A value twice the amplitude is shown as the measured
value in the display labeled
“amplitude” (L)
. We will
refer to this measured value as “
vibration height
”
throughout these instructions.
Fig. 5
When the AS200 is switched on, the vibration height will
be set at the default value of 1.50 mm.
Setting the vibration height, from 0.20 to
3.00 mm: Fig. 5
Reduce:
* The
M
button reduces the vibration height down to as little
as 0.20 mm, in discrete steps.
* Hold down button
M
; after 5 sec. the rapid adjustment
function will commence.
Once the 0.20 mm value is reached, the system will
cycle back to 3.00 mm and continue from there
Increase:
* Pressing
the
N
button increases vibration height, in
discrete steps, up to a maximum of 3.00 mm.
* Hold down button
N
, after 5 sec. the rapid adjustment
function will commence.
Once the 3.00 value is reached, 0.20 mm will once
again appear.
Naturally, your AS200 can only achieve the vibration
heights which are within the values shown in the loading
diagram.
