5
3. If you are cutting speaker holes, refer to the
specification chart on page 9 to determine
the nominal mounting diameter.
4. Mark the locations for the speaker mounting
screws. Drill the holes with a 1/8-inch drill bit.
5. Feed the speaker wires through the opening and
connect to the speaker terminals. Take care to connect
the negative wire to the negative (-) speaker terminal,
and positive to the positive (+) speaker terminal.
6. Fit the speaker into the cutout. Mount them using the
enclosed screws. Tighten until the speaker is snug and
in place to prevent rattling. Do not overtighten screws.
INSTALLATION INSTRUCTIONS
