MOBI Cube Speaker Instructions
Thank you for purchasing this Mobi product. To maximize your satisfaction please become familiarized
with this entire document. Enjoy!
Note: Your Mobi Cube Speaker needs to be fully charged before use.
Charging Instructions
The MOBI Cube Speaker should be fully charged for 4 hours before use. Plug the included micro USB
cord into the ‘5V IN’ port on the bottom of the speaker, and the other end into a USB AC adapter or USB
port on a PC. The unit will have a flashing red light on the top side to indicate unit is charging. The
flashing red light will turn green once the unit is fully charged and ready to use. The green light will turn
red once the battery level is at 20% or lower.
Note: The device can be used via Bluetooth or AUX mode while being charged.
Playing Music via Bluetooth Mode
1.
To turn speaker on, press and hold the
button for 1 second located on the bottom of the
unit. A green light will appear on the top side to indicate that the unit is on. A blue light will flash
indicating that it is searching for a Bluetooth connection.
2.
While your Bluetooth enabled device is in search or scan mode, it should discover a new profile
called “MOBI Cube”. Select this profile to sync your device to the speaker.
3.
It will then make a beep sound when it has successfully syncs to your device. If the device does not
sync, turn the Cube Speaker OFF for 30 seconds: turn it back ON and try again.
*If there was a previous unit linked with your device, it may be preventing the speaker from
pairing. If that is the case, please turn off your Bluetooth settings and try again.
Note: Only 1 Bluetooth device can connect to the speaker at a time.
*When the unit is left untouched with no Bluetooth, it will automatically shut off.
Playing Music via AUX Mode
1.
Turn the speaker on by pressing the
button located on the bottom of the unit. A green
light will appear on the top side to indicate that it is on.
2.
Connect one end of the 3.5 mm audio cable to the AUX In port located on the bottom of the unit.
3.
Connect the other end to your audio device.
Note: Connecting the audio cable will override Bluetooth mode. Speaker will automatically switch to AUX
mode when audio cable is connected.
LED “Light Show” Feature
1.
To turn on the LED light show feature, press the
button on the bottom of the unit.
2.
Continue to press the
button to cycle through the 5 different light show modes (6
th
press
turns the light mode off).
