iBreeze BPAP Systems User Manual
9
3. Plug
the power supply cord’s connector into the power inlet on the side of the device.
4. Verify that the plug at the side of the device, at the power supply, and at the electrical
outlet are fully inserted.
WARNING:
During use if the power cord is disconnected or a power failure, the device buzzer
alarm beeps. Please stop using it and check the power status.
Please do not contact with the DC in connector when it was broken.
Please avoid arcing, wiggling, or dropping the power supply on hard surfaces.
Please periodically inspect electrical cords and cables for damage or signs of wear
and to discontinue use and replace if damaged.
Please first check the DC connector could be used normal and not breaking free.
Never place the power cord around the neck.
Do not use any small parts to fix power cord in position as they might be accidentally
swallowed.
7.3 Connecting the Breathing Circuit
To use the system, you need the following accessories in order to assemble the
recommended breathing circuit:
Resvent interface (nasal mask or full face mask) with integrated exhalation port.
Resvent flexible tubing, 1.8 m.
To connect your breathing circuit to the device, please follow the below steps:
1. Install the connector to the back of the device, and connect the tubing with it.
Note:
If you are using a standard tube (not shown) instead of a heated tube, simply
slide the tubing over the air outlet port on the therapy device.
