Restwell Swivel Massage Chair, Инструкции по сборке и эксплуатации

Страница: 5 / 10

8 7
Slide the spacer (9) over the pin on the underside of the seat (B), make sure that the slot
fits over the bar, slide on the washer (8). Fit the inner armrest (C), bottom of the tube over
the pin and the top of the tube onto the backrest. Tighten the small phillips head screw
on the underside of the inner armrest (*). Screw the top end of the inner armrest (C) to
the backrest (A) using 1 x 55mm bolt (12), do not fully tighten at this time.
Screw fit the adjuster knob ( 7), through washer (5) and the inner armrest.
Turn the seat over and repeat with the other side.
Step 5
a: With help, slide the seat assembly into position on the base unit. The two pins on the
end of each inner armrest (C) slide into the holes on the front of the legs ( E).
b: Position the inner armrests (C) on top of the legs (E), secure each inner armrest in
position using 2 x 70mm Phillips bolts ( 13).
Note: It may be necessary to adjust the ‘slot head screws (*)’ on the inside of the legs (E)
to get the 70mm bolts ( 13) to fit, the slots should be vertical and line up with the screws.
Finally, tighten the 55mm bolts (12) onto the backrest and the 18mm bolts ( 1) on the
inside of the legs (see step 1).
Step 6
a:
b:
Chair Assembly Chair Assembly
B
12
A
C
C
B
E
C
E
C
7
5
8
9
* 12
1
13
*