OPERATION MANUAL
CONTENTS
I.
Warning Notes
1
II.
Introduction
2
III. Initial Setup
3
IV. Instructions For Checking O
2
Concentrators
4
To Turn Unit On and Off
4
Measuring Oxygen Concentrations
4
V. Instructions for Spot Checking Liquid Oxygen
Vessels or Oxygen Cylinders
5
VI. Verification & Calibration Instructions
6
Pure Oxygen Verification Procedure
6
Quick "One Step" Pure Oxygen Calibration
6
Full "Two Step" Calibration Procedure
7
VII. Maintenance
8
Battery Replacement
8
Cleaning
8
VIII.
Environmental
Effects
Temperature
9
Barometric Pressure
9
Vibration
9
Relative Humidity
9
IX. Unit Specifications
10
X. Frequently Asked Questions
11 - 12
XI. Trouble Shooting Check List
13
XII.
Warranty
15
Ultrasonic Oxygen Indicator
WARNING NOTES
USAGE:
The
Respond
O
2
™
Ultrasonic Oxygen Indicator is designed
for intermittent usage to determine the
oxygen concentration
produced by an oxygen concentrator. It may also be utilized to do spot
checks of gaseous or liquid oxygen.
WARNING:
The unit is not designed nor intended for use in
anesthesia applications, or for monitoring oxygen concentration from
any source other than a conventional oxygen concentrator using
molecular sieve beds. This unit will not withstand fluid spillage. The
unit will not withstand mechanical shock or vibration.
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and if not installed in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, the user
is encouraged to try and correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna
Increase the distance between the equipment and receiver.
Connect the equipment into an electrical outlet on a different
circuit from which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
1
Ultrasonic Oxygen Indicator
