immediately generate a Full Alarm condition. On
returning to and entering the property the system must
be Disarmed before opening any protected door or
entering an area protected by a PIR movement
detector otherwise a Full Alarm condition will occur.
Delay mode will arm the system with a 15 second
entry/exit delay. On arming the system in Delay mode
there will be a 15 second delay before the system
becomes fully active. This allows time for you to leave
the property before the system becomes fully active.
On returning to and entering the property by opening
a protected door or moving through a PIR protected
area the system will be triggered and the Siren will
emit a single long beep. However, a Full Alarm will not
be initiated until the 15 second entry delay has expired
during which time the system should be Disarmed. If
the system is not Disarmed within the entry delay
period a Full Alarm condition will occur.
If a Full Alarm condition is initiated following an
intrusion and a detector being triggered, (while the
system is armed), the Siren will sound continuously
until the pre-set alarm duration time (1 or 3 minutes)
expires when the siren will cease. The system will
then immediately automatically reset and re-arm
itself. In the event that a further detector is triggered
the system will once again initiate a Full Alarm
condition. This process can be repeated up to three
times after which time the system will not
automatically reset.
If a Full Alarm condition is initiated accidentally the
alarm can be stopped immediately by pressing the
‘DISARM’ button on the Remote Control.
Arming The System Instant Mode
The system can be armed in Instant mode using either
the Remote Control or the Keypad as follows:
Remote Control:
Press the ‘INSTANT-ARM’ button,
The Siren will acknowledge the signal by beeping
once.
Keypad:
Enter the User Access code followed by the
‘INSTANT-ARM’ button
,
The Siren will acknowledge the signal by beeping
once.
Arming The System In Delay Mode
The system can be armed in Delay mode using either
the Remote Control or the Keypad as follows:
Remote Control:
Press the ‘DELAY-ARM’ button,
The Siren will acknowledge the signal by beeping
once and then again after the 15s entry/exit period has
expired. The system will not be fully armed and active
until after the second beep.
Keypad:
Enter the User Access code followed by followed by
either ‘DELAY-ARM’ button.
, or
The Siren will acknowledge the signal by beeping
once and then again after the 15s entry/exit period has
expired. The system will not be fully armed and active
until after the second beep.
DISARMING THE SYSTEM
The system can be Disarmed using either the Remote
Control or the Keypad as follows:
Remote Control:
Press the ‘DISARM’ button,
The Siren will acknowledge the signal by beeping
twice.
Keypad:
Enter the User Access code followed by the ‘DISARM’
button
,
The Siren will acknowledge the signal by beeping
twice.
IMPORTANT: If, when the system is disarmed, the
siren emits a series of ten rapid beeps, this indicates
that a Full Alarm condition has been triggered whilst
the system was armed was armed. Check the
security of the property before entering.
SA1/SA2/SAC1
15
?
?
?
?
1
2
?
?
?
?
1
?
?
?
?
