Respironics bilichek, Руководство пользователя

Страница: 19 / 25

ENGLISH
12.0 INSTRUCTIONS FOR USE
12.1 Completing a Patient Test -- Performing the Calibration
TO TURN THE UNIT ON
•
If there is no battery pack, insert a charged battery pack into the
battery compartment.
•
Apply a new Bili Cal ™ Individual Calibration Tip to the unit.
•
Firmly press the Bili Cal Tip on to the Bili Chek® Hand-Held Unit to ensure
proper seating of the Tip.
•
Press and release either F1 or F2 .
•
The unit will perform a self-test, momentarily displaying all LCD indicators,
Measurement Status Indicator, software revision, configuration screen and end at
the home screen.
NOTE: Press and hold F1 to illuminate the back light of the display window. This option is not
available in the Set-up Mode.
NOTE: The home screen will remain until the TRIGGER button is pressed or the user Set-up Mode is
entered.
CALIBRATION
•
Press and release the TRIGGER button to start calibration.
•
Three dashes (---) will flash in the display window and the MSI will be amber if
a Bili
Cal Tip is in place, indicating the system is ready to calibrate. If a
Bili Cal Tip is not in place the MSI will be red. Attach a Bili Cal Tip before
continuing.
•
Press and release the TRIGGER button. The dashed lines will stop
flashing indicating that the system is calibrating.
•
When calibration is complete the MSI will be amber, you will hear a beep (if the
audio is on), and the display window will read “005”.
NOTE: If a problem occurs during calibration an error message will be displayed. Refer to the
Troubleshooting Section of the manual for instruction.
NOTE: To exit during calibration or measurement, press F1 and F2 to return to the home screen.
The user will then need to repeat the procedure.
NOTE: This unit is equipped with a Critical Power-Off feature. After completing the calibration, the
unit will sound an alarm if no measurement is performed within a preset period of time. The
unit will power-off 20 seconds later if F1 or F2 is not pressed. If the unit automatically shuts
off, it is necessary to perform another calibration after restarting.
Individual Tip Placement
17