English
User manual for Microwave
-
the Turntable axle –drive
shaft
Failure to carefully remove
plastic films and stickers may
lead to a fire hazard.
d) Clean the oven interior with a
damp cloth.
Do not use sharp cleansers
or scouring agents!
e) Unpack the turntable (not all
models are equipped with) and
its undercarriage
f) Place the undercarriage in the
circular track on the oven
interior floor
g) Lay the turntable onto the
undercarriage. By gently turning
it, the guide fits into the drive
shaft.
Place the appliance on an
even and non-skid
surface
.
It must be
stable
enough to easily
support the appliance even if the
oven contains goods.
For
countertop type
s
l
eave a
space of at least 10 cm
between the foremost edge of
the worktop and the front of
the oven door.
You will thus prevent the appliance
from tilting forward when the door is
open.
Install the oven in a place
where it is protected against
splashing water or dripping
liquids.
Never
operate the appliance
outdoors.
Sunlight and
humidity may impair operational
safety.
Never expose your microwave
oven to direct sunlight
(overheating hazard).
Do not install the appliance in
the immediate vicinity of heat
sources such as radiators or
cookers.
For countertop type
t
he
following
minimum clearances
between other objects / walls must
be maintained for safety purposes:
- Side l/r clearance at least 5 cm
- Rear clearance at least 10 cm
- Upper clearance at least 10 cm
The appliance
must not be
built into a cupboard.
The oven
must not be built in
underneath a panel or a
cupboard.
For some models a built under -
mounting set is commercially
available. Please ask your
dealer or the respective
customer support service.
CAUTION !
During operation clouds of steam
escape through the air vents of the
appliance and it may get very hot
within the space of the above
mentioned minimum clearances.
The microwave oven should thus
be installed so that no objects
sensitive to heat or moisture are
located near the minimum
clearances.
Avoid any possible overheating of
the oven caused by unintentionally
covering or sealing the air vents.
GB
fi211206mid
GB 8
