Remote control
Changing the lights:
1. Open the glass and remove the grease filter (
Fig. 1)
.
2. Use a tool or the hand to press the spring splinter of both
sides of LED light (
Fig. 2)
to the inside, until the light is
pressed out.Then slightly pull the light connecting wire out,
and dismantle the terminal of the light connecting wire. (
Fig.
3
)
Press this botton once to turn on the light on the cooker hood
Press this button one or more times to select the motor
speed. (low, mid, high)
Press this button to switch the timer function ON or OFF
Press this button one or more times to reduce the motor
speed.
Press the botton once again to switch off the light on the
cooker hood
When the previous code has been cleared, the cooker hood turns back to standby mode, touch
the power key
E
on the cooker hood for 5 seconds. The key illuminations starts to flash from
one key to the othe. The cooker hood is in connection mode, then, tocu any key on remote
control to confirm the connection.
– Dimensions: (
Fig. 2
)
3. Apply the reverse procedure to install the light back.
ILCOS D code for this lamp is: DSS-1.5/65-S-120/33
– LED modules –rectangle LED light
– Max wattage: 2×1.5 W
– Voltage range: DC 12V
Fig. 2
Fig. 1
Fig. 3
fi200505atNEG
1
1
Technical changes reserved
