CH 11050 ISB
CH 11050 ISW
A
Timer ON/OFF key
B
Lamp OM/OFF key
C
LED Display
D
Speed selection key
E
Power ON/OFF key
1. Touch the Power key
E
, to turn the cooker hood motor ON
Connecting the remote control
Connection process between remote control and cooker hood
English
Oberating- and Installation Instruction cooker hoods
15. Appliance opperating
Key- / Switch functions
2. Touch the Speed key
D
time after time, till the motor runs at the desired speed (as low,
mid, or high) The LED display will indicate as 1-2-3-1-2… circularly.
4. To use the timer, touch the button
A
. The hood enter in to the timer status (the timer runtime
is max. 9 minutes), and the remaining runtime will be showm by counting down 9.8.7.6.... on
the LED display
C
. After the set time has elapsed, the hood is automatically switched off and
the lamp goes out.
3. Touch the Lamp key
B
, the light goes on, press this button again, the light is off. Please
note the Lamp is not under control of the on/off button.
When using the remote control the first time a connection to the cooker hood mast be
established. The remote control may be able to control several cooker hoods at the same
time.
Press the Power button
E
on the cooker hood for 5 seconds within 15 seconds after
connecting the cooker hood to the mains. The key illuminations starts to flash from one key to
the other. The cooker hood is in connection mode. Touch any button on the remote control to
confirm the connection. The connection process is complete (coded) and the remote control
can be used for speed selection, lighting and timer setting.
If you want to connect again, you will need to clear the code that has been set up previously.
To clear the code, touch the power key
E
for 5 seconds. The indicators light begin flashing
from one button to another. Tthe cooker is in connection mode. Then, touch the poer key
E
again for 5 seconds. The previous connection code is cleared
GB
A
B
C
D
E
fi200505atNEG
10
Technical changes reserved
