EN1R-1020 1004RA-NE
4
Capacity (
⊗
p = 5mbar, 1013 mbar and 15
°
C)
VK4110V/VK8110V: 3.2 m
3
/
h
air
VK4115V/VK8115V: 3.4 m
3
/
h
air
VK4125V/VK8125V: 2.2 m
3
/
h
air
VK4115VB/VK8115VB: 4.4 m
3
/
h
air
VK4115VE/VK8115VE: 0,34 ... 3,2 m
3
/
h
air
NOTE:
Versions with side outlet connection only have a
0.2 m
3
/
h
air lower capacity.
Versions with external thread connection have a
0.3 m
3
/
h
air lower capacity.
Capacity curves are available on request.
Valve classification
Type
Class
1
st
valve
2
nd
valve
VK4110/VK4115
VK8110/VK8115
Class B
Class C
VK4120/VK4125
VK8120/VK8125
Class B
Class B
Timing
Closing time:
≤
1 s
Opening time: see table
Model
Time till P
o
>= 100 P
a
VK4115V/VK8115V
< 1 s
VK4115VB/VK8115VB
< 1.5 s
VK4125V/VK8125V
< 1.5 s
Mounting holes
Two mounting holes at the bottom for thread forming screws.
The four holes at inlet and outlet for mounting a flange on the
gas control are provided with M4 thread with min. 6 mm full
thread.
In case of side outlet the three holes for mounting the flange
are provided with M5 thread with a minimum of 6 mm full
thread.
Electrical data
Coil indication
Supply voltage
220/240 Vrac
220 V, 50/60 Hz using rectifier
240 V, 50/60 Hz using rectifier
110 Vrac
110 V, 50/60 Hz using rectifier
24 Vrac
24 V, 50/60 Hz using rectifier
Electrical connection
Molex 1.1 square pin header
The 24 V and 220/240 V versions gas controls can be
connected to any standard
DBI
control with a 24 Vac, or
220/240 Vac output by using a rectifier plug 45.900.441-
Fig. 3. Mounting of rectifier plug
IMPORTANT
Warranty claims are not accepted if not the
specified plug/rectifier circuit is used.
Electical protection of gas control with rectifier plug
IP 40
Mounting of rectifier plug
See fig. 2.
Mounting screw of rectifier plug
Torque: 40 Ncm max.
Fig. 4. Coil connection
Current and power consumption at nominal voltage
Pin number
1 2 3 4 5
Voltage
Current (mA)
Power
consumption (W)
220 V, 50/60 Hz
48
9.4
240 V, 50/60 Hz
52
11.2
110 V, 50/60 Hz
89
8.8
24 V, 50/60 Hz
424
9.2
