R7284 SERIES ELECTRONIC OIL PRIMARY
69-2500—02
2
• Holding all 3 buttons longer than 2 seconds in any state puts
the display in the Installer Setup (ISU) mode.
• Pressing “i” in any state enters the Diagnostic screen if
diagnostics are enabled outside of the Installer Setup mode.
• Pressing up or down in any screen enters Error History if
diagnostics are enabled outside of the Installer Setup mode.
Below is a typical progression of screens through a normal cycle.
If at any point there is an event generating a lockout, one of the
following screens will be displayed.
Installer Setup (Advanced Interface)
Installer setup is entered by pushing all three buttons
simultaneously for 2 seconds.
NOTE:
Not all parameters are adjustable in all models. Param-
eters not available for adjustment will display “Locked”
when an attempt is made to modify them.
Pressing up or down during the Ignition Trial
enters pump prime.
Each press of the up button adds a minute, each
press of the down button subtracts a minute
from the pump prime time.
Control is in Soft Lockout. Control will recover
when error clears or after specified time.
Control is in Hard Lockout. Hold “i” for at least
2 seconds to reset.
Hold the “i” button longer than 10 seconds to
return to Standby.
If QUIT is selected, an “i” button press displays
the Re-baseline option.
If CONT is selected, an “i” button press goes to
“Installer Setup”.
