Residential Control Systems TR16, Инструкция по установке и эксплуатации

Страница: 14 / 27

DCN: 141-00930-07 09/06/04 14
TR16 Wall Display Unit Installation
WDU Location Choose a location that best represents the temperature of the area to be controlled. Avoid
locations that are subject to drafts, from doors and windows, or areas with direct sunlight exposure.
WDU Mounting Route the wires to the WDU through the access hole in the back of the case. Mount the
WDU to the wall with the screws and anchors provided. Be sure to plug any large access hole in the wall
with sealer or insulation to prevent wall drafts from affecting WDU operation.
WDU Prewiring The recommended wiring to the WDU from the Control Unit should be a two twisted pair
cable, 24 Ga minimum. Cat 3 or 5, 4 pair cabling is acceptable. In retrofit applications the existing thermostat
wiring (a least 4 wires) may be adequate. However, such non-twisted wiring may be subject to interference
due to noise from adjacent wiring or other sources.
Wiring to the Wall Display Unit
Remote Sensor Wiring
G
+12
C
D
1 POWER GND
2 POWER +
3 COM CLOCK
4 COM DATA
WIRING
ACCESS
HOLE
J1
WDU WIRING DIAGRAM
TS16 WDU
BASE
Hook TOP here
and rotate into
base. Be sure
pins engage in
connector ok.
TO CLOSE
OPENING AND CLOSING THE WDU CASE
TO OPEN
PULL FROM LOWER CORNERS
OPEN
CLOSE
BASE
For Remote Sensor
G
+5
C
D
J2
TR16 CONTROL UNIT
GND G
+12VDC +V
CLOCK C
DATA D
TWISTED PAIR 22 GA WIRE RECOMMENDED
TR16 WALL DISPLAY UNIT
WDU
+12V
GND
DATA
CLK
J1
** CAUTION **
DO NOT MISWIRE
WDU
CONNECTIONS
OR
DAMAGE WILL
RESULT