Tactical ResQmax Operation Manual
Tactical ResQmax Operation Manual
18
Note
Safety Assembly & Launcher Bleed Screw
Safety Push Knob
The Safety Push Knob is a circular black button
located on the same side of the launcher as
the Valve Key, and directly above the trigger.
This Safety Push Knob is at rest when
protruding slightly from the side of the launcher
housing. (fig. 13a)
The Safety Assembly engages automatically each
time that a projectile is inserted into the
launcher. An audible “Click” indicates that the
safety has engaged.
Press the Safety Push Knob to the “off” position
immediately before firing the launcher. When in
the “off” position the Safety Push Knob remains
recessed inside the cavity about ¼” or 6 mm.
(fig. 13b)
After firing the launcher the Safety Assembly
will re-set itself to accept the next projectile.
When a new projectile is loaded the trigger
will automatically move forward once the safety
is engaged.
Re-Setting the Safety
If the Safety Push Knob has been pressed to
the “off ” position – and for any reason it
becomes necessary to re-set the Safety without
firing the launcher – reach inside the cavity
holding the Safety Push Knob and rotate the
Safety Push Knob clockwise. A rotation of only
a few degrees is required. (fig. 13c) The Safety
Push Knob will return to its rest position,
protruding slightly from the side of the launcher
housing – indicating that the Safety Assembly
has been re-engaged, and is in the “on” position.
(fig 13a)
Figure 13a
Note
Figure 13b
Note
Figure 13c
Note:
If the trigger is
moved forward
manually prior to
another projectile
being inserted, it is
necessary to press
the Safety Push
Knob to release the
safety internally,
prior to inserting
another porjectile
19
Step 5
Step 4
Connecting the Launcher to the Line Container
1. Place the inverted “T” bracket (on the bottom of the Barrel at the front) on top of the line
container, just behind the inverted “T” groove on the upper portion of the front of the line
container. (fig 12a -- Step 1)
2. Locate the bottom of the handle so that notches on the handle will engage with the flange at
the rear of the line container. (fig 12a -- Step 2)
3. Slide the launcher forward inside both the front and rear grooves of the line container
simultaneously. Push firmly forward until the catch on the launcher automatically engages in
the locking hole in the line container. (fig 12a -- Step 3)
4. Attach the “dead end” of the line (with snap shackle) to the eyelet behind the “T” Bracket on
the underside of the barrel casing. (see Figure 11d). This will insure that the line does not
separate from the launcher after discharge. Alternatively, the dead end may be lashed to a
secure anchor prior to or after discharge, while the launcher is readied for subsequent shots.
5. Attach the quick-connect link on the projectile bridle lines to the “live end” of the line.
To Disconnect the Line Container from the Launcher push down on the Line Container Catch
located at the front of the Launcher, just below the barrel opening, and slide the launcher rearward
(fig 12b -- Steps 4 & 5).
Step 3
Step 1
Step 2
Figure 12a. Connecting the Launcher to the Line Container
Figure 12b. Disconnecting the Launcher from the Line Container
Note:
If there is line in the
container it is first
necessary to
disconnect the “live
end” from the bridle
lines and the “dead
end” from the
launcher eyelet..