FCC Part 15
The modem generates and uses radio frequency energy. If it is not installed and used properly in strict
accordance with the user's manual, it may cause interference with radio and television reception. The modem has
been tested and found to comply with the limits for Class B computing devices in accordance with the
specifications in Subpart B, Part 15 of the FCC regulations. These specifications are designed to provide
reasonable protection against such interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. FCC regulations require that shielded interface cables be
used with your modem.
If interference does occur, we suggest the following measures be taken to rectify the problem:
1) Move the receiving antenna.
2) Move the modem away from the radio or TV.
3) Plug the modem into a different electrical outlet.
4) Discuss the problem with a qualified radio / TV technician.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance to the FCC Rules could
void the user's authority to operate this equipment.
Cable connections:
All equipment connected to this modem must use shielded cable as the interconnection means.
Notes:
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received including interference that may cause undesired
operation.
Chapter 1 Introduction
The ADSL2+ VoIP Router provides home connectivity to an ADSL service provider network over an
ADSL/Asynchronous Transfer Mode (ATM) physical layer. The router can run upstream maximum transmission
rates of 2Mbps and downstream maximum transmission rates of 24Mbps. The actual rate depends on the
copper category of your telephone wire, distance from the central office and the type of ADSL2+ service
subscribed. Four ports switch is provided for connection to an Ethernet LAN or Ethernet-equipped PC, and this
router is easy to install and to configure. Connect your phones or fax machines to the phone ports, with separate
Internet phone services and phone numbers, so you can have up to two Internet phone lines delivered through
the Internet connection.
4
Содержание WR3211
